Spectacular Tips About How To Check The Smps

Remove the connections that are connected to motherboard from smps.

How to check the smps. Use a paper clip and bend it in u shape. It might require to start the smps w. Connect the smps to 230vac and connect the appropriate load to check to working of smps.

To do so, remove power cable form smps and unplug all connections of peripherals (hard disk motherboard, dvd etc.) because it will save the damaging of harddisk or motherboard if any. Locate the green and select any one of the black wire of the bigger. Measure the output voltage of smps by a multimeter( indicate the output voltage 12v or 24v.

Remove the connections that are connected to motherboard from smps. You can check with a piece of power code ( wire) or with multimeter. The shown burnt smps can be repaired with the following simple steps.

Using two 10× probes and a coaxial 1× connection to measure the voltage noise on the smps output. Smps is the switched mode power supply circuit which is designed for obtaining the regulated dc output voltage from an unregulated dc or ac voltage. Use a paper clip and bend it in u shape.

2) without any doubt you will find. Use whichever is available to you following two steps. How to check smps/power supply unit is working or nothave you ever wondered how to start a smps without the motherboard.

Figure 4 shows the noise measured using these three methods. Remove the connections that are connected to motherboard from smps. It is very easy to check smps problem.